No state found

[GrimmJeel]

I finally got 3d ripper dx to work, and When I hit F12 or any other function, I get "No State Found", is there any way to fix this

[Friedslick6]

(09-15-2011 02:25 AM)GrimmJeel Wrote:  I finally got 3d ripper dx to work, and When I hit F12 or any other function, I get "No State Found", is there any way to fix this

It depends on the program that you're trying to use 3D Ripper DX on. This sounds like just a key binding interference though. Make sure that the key binds of the program you are using do not interfere with the key binds of 3D Ripper DX.

[GrimmJeel]

Well I re- key mapped 3d ripper dx and Dolphin,maybe I'm forgeting something

[Shadowth117]

(09-16-2011 12:26 PM)GrimmJeel Wrote:  Well I re- key mapped 3d ripper dx and Dolphin,maybe I'm forgeting something

If you re mapped everything then it *should* be fine, but you may want to check your bindings again just in case. I guess if that doesn't work you could just try rebinding them again, but otherwise I don't know what to tell you.